First download drawings (download wolverine.pdf
), print, cut and glue (or glue then cut)
When gluing is better to use masking tape, as it can be without prejudice to peel off the paper on error
Step 2
Glue all parts using foam glue according to the instructions on the drawing. Spars I have made of wooden sticks for flowers, they are quite long and thin
Step 3
Merge the nose of the plane, so that all parts were kept at the desired angle on the drying time of the adhesive anchoring by needles
Iron bracket at the top of the photo holds together the two parts of the fuselage, at the time of glueing
Step 4
The fuselage bends in this place, so I pasted a small spar of the line
Step 5
The nose has dried up, it looks like this without needles
Attach a piece of foam on top of it
The same with the upper side
Step 6
Sew up the bottom of the fuselage, cover all seams with glue for more strength
Use needles of course
Step 7
Attach engine mount of PCB
Step 8
Elevons mounted on hinges of scotch or magnetic tape, boar cut from PCB
Step 9
Draft from the servos to the boar I made from bamboo sticks. To it with glue and thread attached clip, then beauty is delayed shrinking
Careful work with glue such as "Moment" near foam, because one drop of it is able to eat through a big hole!
Step 10
Glue keels. I have too big screw, so we had to make a small slit under it
Electronics of the RC plane
Step 11
Install all electronics (battery, speed controller, receiver) in accordance with that centering on the drawing
Coloring
Step 12
Cut parts from colored adhesive tape and paste them on the model.
How to cut: stick tape on the glass and cut with a scalpel
Step 13
Luc hinged on the one hand movably fastened on tape, the other is fixing with magnets