
Homemade hookah




SMOKING IS DANGEROUS FOR YOUR HEALTH! You do not care? Then I present to your attention a topic about how to make homemade hookah out of useless computer parts and scrap materials.

- Laser printer cartridge (in my case, the cartridge HP 1005)
- 2 tubes of magnetic brushes of different diameters, also from the cartridges. I've used on HP 1005 and HP 1010 (could use FX10)
- Computer cooler grid
- The toner funnel, it will be the mouthpiece
- Hose. I use the water hose
- The coupling nut, hose connection
- Nut for coupling
- Jar of coffee

- Scissors
- Screwdriver Set
- Hacksaw
- Drill
- Glue
- Pliers
- Drill
- Cutters
- Step 1
Drill a hole in one edge of a cartridge tube to insert a tube into the hole of the magnetic brush (from 1010). - Step 3
Tank is a coffee jar. Make a hole in the cap for coupling. - Step 5
It serves to equalize the pressure and venting of excess air of the homemade hookah's tank to prevent water geting into the shaft. Also, the valve is used to purge. While not strong drag valve need to pass air into tank, but while long strong drag - must totally blocked air. All air will go through shaft.
The valve consists of two bolts with a large hat, part of a gel pen and the housing. The housing is made from metal tubing, for example from a television cable connector. One end is threaded into the cap of the tank and on the other end there is two recesses are made for air passage.
How to make a hookah
Making a shaft
Diy hookah's tank
Valve
Chilim


- Smoked perfectly
- Has a valve
- You can make a fruit hookah